OPERATION
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the battery pack will become hot. You should let a hot bat- tery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, this will cause the green LED to come on instead of the red LED. After 30 minutes, reinsert the battery pack in the charger. If the green LED continues to remain on, return battery pack to your nearest Sears Repair Center for checking or replacing.
BATTERY PACK
SHOWN IN CHARGER
NOTE: This situation only occurs when continuous use of the tool causes the batteries to become hot. It does not occur under normal circumstances. Refer to “CHARG- ING A COOL BATTERY PACK” for normal recharging of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Sears Repair Center for electrical check.
CHARGER |
| |
RED LED ON INDICATES |
| |
FAST CHARGING MODE |
| |
GREEN LED ON AFTER FAST CHARGING |
| |
CYCLE, INDICATES FULLY CHARGED | ||
BATTERY PACK AND IN TRICKLE | ||
| ||
CHARGE MODE. |
|
YELLOW AND GREEN LEDS ON INDICATES DEEPLY |
|
DISCHARGED OR DEFECTIVE BATTERY PACK. | Fig. 7 |
|
14
