ASSEMBLY
UNPACKING
This product has been shipped completely assembled.
nCarefully remove the tool and any accessories from the box. Make sure that all items listed in the packing list are included.
nInspect the tool carefully to make sure no breakage or damage occurred during shipping.
nDo not discard the packing material until you have carefully inspected and satisfactorily operated the tool.
nIf any parts are damaged or missing, please call
PACKING LIST
Reciprocating Saw
Blades (2)
Battery Pack
Charger
Operator’s Manual
WARNING: If any parts are missing do not operate this tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury.
WARNING: Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
WARNING: To prevent accidental starting that could cause serious personal injury, always remove the battery pack from the tool when assembling parts.
OPERATION
WARNING: Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury.
WARNING: Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury.
APPLICATIONS
You may use this tool for the following purposes:
nCutting all types of wood products (lumber, plywood, paneling, composition board, and hard wood).
nCutting masonite and plastic.
nCutting drywall.
nCutting metals such as sheet steel, pipe, steel rods, aluminum, brass, and copper.
CAUTION: To prevent damage to the battery pack, remove the battery pack from the charger immedi- ately if no LED comes on. Return the battery pack and charger to your nearest service center for check- ing or replacing. Also, if you are removing the battery pack from the charger and no LEDs are on, return both the battery pack and the charger to your near- est service center. Do not insert another battery pack into the charger. A damaged charger may
damage a battery pack.
LED FUNCTIONS OF CHARGER
LED WILL BE ON TO INDICATE STATUS OF CHARGER AND BATTERY PACK:
nRed LED on = Fast charging mode.
nGreen LED on = Fully charged and in trickle charge mode.
nGreen LED on = When battery pack is inserted into charger, indicates hot battery pack or that battery pack is out of or below normal temperature range.
nYellow and Green LEDs on = Deeply discharged or defective battery pack.
nNo LED on = Defective charger or battery pack.
CHARGING THE BATTERY PACK
The battery pack for this tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it until the green LED on the front of the charger comes on.
NOTE: Batteries will not reach full charge the first time they are charged. Allow several cycles (operation followed by recharging) for them to become fully charged.
10
