Sears 316.35084 manual Maintenance And Repair Instructions, Air Filter, Fuel Filter

MAINTENANCE AND REPAIR INSTRUCTIONS

MAINTENANCE REQUIREMENTS

CHECK FOR DAMAGED OR WORN PARTS

Check a Sears Service Center for replacement of dam- aged or worn parts.

NOTE: It is normal for a small amount of oil to appear under the saw after the engine stops. Do not confuse this with a leaking oil tank.

•STOP Switch - Ensure STOP switch functions properly by moving the switch up to the STOP position. Make sure the engine stops; then restart engine and continue.

•Fuel Tank - Do not use saw if fuel tank shows signs of damage or leaks.

•Oil Tank - Do not use saw if oil tank shows signs of damage or leaks.

CHECK FOR LOOSE FASTENERS AND PARTS

•Chain Brake Nuts

•Chain

•Muffler

•Cylinder Shield

•Air Filter cover

•Handle Screws

•Vibration Mounts

•Starter Housing

•Front Hand Guard

AIR FILTER

CAUTION: Never operate saw without the air filter.

Dust and dirt wil be drawn into engine and damage it. Keep the air filter clean.

1.Remove the top cover (A) by loosening the cover retaining screws. Cover will lift off (Fig. 31).

2.Clean air filter. Wash filter in clean, warm, soapy water. Rinse in clear, cool water. Air dry completely.

NOTE: It is advisable to have a supply of spare filters.

3.Install air filter. Install engine / air filter cover. Make sure cover fits properly. Tighten the cover retaining screws securely.

WARNING: To avoid serious per- sonal injury, always

turn your unit off and allow it to cool before you clean or service it.

B

A

Fig. 31

FUEL FILTER

CAUTION: Never operate saw without the fuel filter.

The fuel filter should be replaced after each 10 hours of use. Drain fuel tank before changing.

To empty fuel tank before removing fuel filter.

1.Pull fuel filter (A) out of tank with a bent wire (B) or long needle nosed pliers. Disconnect filter and discard (Fig. 32).

NOTE: Do not pull hose completely out of tank.

2.Install a new fuel filter on hose and push hose and fil- ter assembly back into tank so filter is positioned in front right corner.

3.Fill tank with fresh fuel/oil mixture. See Oil and Fuel Information. Install fuel cap.

A B

Fig. 32

18