Cleaning the Shutlle Race
This area must be kept free of dust, lint and
occasional tangled thread Clean the shuttle race area about every three months.
o Cleaning the shuttle area (_ Bobbin case
(_) Levers
QShuttle race cover (_) Shuttle
(_ Shuttle race
(_}')Center pin on the shuttle
Q | Shuttle | driver | 0 |
| Pointed | hook |
|
0 | (Oil here) |
|
1- Raise the needle bar to its highest point and remove the bobbin case (_,
2Push shuttle race levers (_ aside Lift shuttle race cover (_Dand take shuttle @ out
3, Clean the shuttle race Owith a lint brush
4, Put a drop of oil on the center pin of the shuttle (_) and shuttle race 0 Do not over oil
o Replacing shuttle assembly
0Bobbin case (_) Levers
(_ Shuttle race cover 0 Shuttle
(_) | Shuttle | race | ® |
(_) | Center | pin on the shuttle |
|
(Z)Shuttle driver Pointed hook
@(Oil here)
1Position shuttle race (_) as illustrated so that shuttle driver (Z) is forming half moon on the left side of the machine
2, Hold shuttle (_ by center pin (_ and position shuttle so as to form a half moon on the right side The pointed hook(_ will be on the bottom
3 Place shuttle race cover (_) into place over shuttle assembly
4., Snap the levers (_) back into the original position
64