Sears 831.297741 user manual Troubi Eshooting, Symptom the Power does not Turn on

TROUBI E:SHOOTING" " '

Most treadmill problems r.an be solved by following the Simple Steps below. Rnd the sym'pomthat ap-- ....

plies, and follow the steps listed.

If further assistance Is needed, call bur toll-free HELPLINE at 1-800-736-6879, Monday through Saturday, 7 a.m. until 7 p.m. Central Time (excluding holidays).

1.SYMPTOM: THE POWER DOES NOT TURN ON

a.Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into a propedy grounded outlet. (See HOW TO PLUG IN THE POWER CORD on page 9.) Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.

b.After the power cord has been plugged in, make sure that the key is fully inseded into the console. Various indicators on the console should light. (See step 1 page 11 .)

c. Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.

d. Check the on/off switch located at the front of the treadmill near the power cord. The switch must be in the =on" position.

Tdpped

Position

"On""_

2.SYMPTOM: THE POWER TURNS OFF DURING USE

a.Check the cimuif breaker located on the treadmill near the power cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in.

c.Remove the key from the console, and reinsed it fully into the console. (See step I on page 11.)

d.Check to make sure that the on/off switch is in the =on" position. (See 1. d. above.)

e.If the treadmill stillwill not run, please call our toll-free HELPLINE.

3.SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON

a.Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of fnte feet or less In length.

b.If the walking belt stillslows when walked on, please call our tolHree HELPLINE.

4.SYMPTOM: AN ERROR CODE ("El," "E2," "E3," "E4," OR "ES") APPEARS ON THE CONSOLE

a.If error code "El" appears in the DISTANCE/INCLINE display, a malfunction may have occurred in the in- cline system. Remove the key, wait for ten seconds, and then reinsed it. If the error cede appears again, call our toll-free HELPLINE. Do not operate the treadmill until the problem is corrected.

b.Error code "E2" may appear in the SPEED display if the SPEED increase or START/PAUSE button is pressed and no movement of the walking belt is detected within seven seconds. Remove the key, wait for ten seconds, and then reinsert it. Make sure that you stand on the foot roils of the treadmill each time you stad the walking belt. If the error code appears again, call our toll-free HELPUNE. Do not operate the tread- mill until the problem is corrected.

2O