Sears 917.28853 Operación, To Check Brake, To Remove Wheel For Repairs, Replacing Battery

OPERACIÓN

Estos símbolos pueden aparecer sobre su tractor o en la literatura proporcionada con el producto. Aprenda y comprenda sus significados.

MARCHA ATRÁS	NEUTRO	ALTO		BAJO	ESTRANGU-	RÁPIDO		LENTO
					LACIÓN
MOTOR		MOTOR		MOTOR	FRENO DE		ALTURA DE LA		LEVANTAMIENTO
APAGADO	SISTEMA ENCENDIDO			EN MARCHA	ESTACIONAMIENTO		SEGADORA		DE LA SEGADORA
FUNCIONAMIENTO
ATRÁS (ROS)
LUCES		BATERÍA		MARCHA	MARCHA	PALANCA DE MANDO
ENSENDIDAS COMBUSTIBLE									PEDAL DE FRENO /
				ATRÁS HACIA ADELANTE			CRUCERO		DE EMBRAGUE
								15	15
ACCESORIO DEL	ACCESORIO DEL		PELIGRO, GUARDE LAS			MANTENGA EL			PELIGROS DE
EMBRAGUE	EMBRAGUE		MANOS Y LOS PIES LEJOS
ENGANCHADO	DESENGANCHADO				AREA DESPEJADA				PENDIENTES

TO CHECK BRAKE

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

1.Park tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake.

2.Disengage transmission by placing freewheel control in “transmission dis- engaged” position. Pull freewheel control out and into the slot and release so it is held in the disengaged position.

The rear wheels must lock and skid when you try to manually push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a Sears or other qualified service center.

TO REMOVE WHEEL FOR REPAIRS

1.	Block up axle securely.
2.	Remove axle cover, retaining ring and

IMPORTANT: Your tractor is equipped with a 12 volt system. The other vehicle must also be a 12 volt system. Do not use your tractor battery to start other vehicles.

TO ATTACH JUMPER CABLES -

1.Connect one end of the RED cable to the POSITIVE (+) terminal of each battery(A- B), taking care not to short against tractor chassis.

2.Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

3.Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

1.BLACK cable first from chassis and then from the fully charged battery.

2.RED cable last from both batteries.

RUEDA LIBRE

(Solamente para los modelos automatico)

No seguir las siguientes instrucciones puede provocar heridas o muerte. Los

(Vea la sección de las reglas de seguridad)

PELIGRO indica un peligro que, si no se evita, provoca muerte o lesiones graves.

ADVERTENCIA indica un peligro que, si no se evita, puede provocar muerte o lesiones graves.

PRECAUCIÓN indica un peligro que, si no se evita, puede provocar lesiones ligeras o moderadas.

PRECAUCIÓN cuando se utiliza sin el símbolo de aviso, indica una situación que puede provocar daños al tractor y/o al motor.

SUPERFICIES CALIENTES indica un peligro que, si no se evita, puede provocar la muerte, lesiones

washers to allow wheel removal (rear

wheels have a square key - Do not lose).

3. Repair tire and reassemble.

NOTE: On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

4.Replace washers and snap retaining ring securely in axle groove.

5.Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, purchase and use tire sealant from Sears. Tire sealant also prevents tire dry rot and corrosion.

Weak or	Fully
Dead	Charged
Battery	Battery

REPLACING BATTERY

WARNING: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from accidental grounding.

símbolos de aviso de seguridadse utilizan para identificar informaciones de seguridad relativas a peligros que puedenprovocar la muerte, heridas graves y/o daños a la máquina.

graves y/o danos a la máquina.

FUEGO indica un peligro que, si no se evita, puede provocar la muerte, lesiones graves y/o danos a la máquina.

Retaining

Axle Ring

Cover

Square

Key

Washers

1.Lift seat pan to raised position.

2.Remove terminal cover.

3.Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.

Seat Pan

(Rear Wheel Only)

TO START ENGINE WITH A WEAK BATTERY

WARNING: Lead-acid batteries gener- ate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE section of this manual). If “jumper cables” are used for emergency starting, follow this procedure:

Terminal	Negative	Nut
Cover		Bolt
	(Black)
	Cable

Positive (Red) Cable

02603

40 25