2.Turn the check over so that it is face down with the MICR characters on the
3.Insert the check straight into the paper inlet, using the right edge of the paper inlet as a guide.
4.Insert the check as far as it will go. The printer will detect the check and start drawing it in.
5.When the printer starts drawing it in, let go of the check immediately. The SLIP light quits blinking but stays on.
6.When printing and MICR reading are finished, the printer ejects the check and the SLIP light starts blinking again.
7.Remove the check by pulling it straight up; do not pull it at an angle. The SLIP light goes on.
See Chapter 3 to find out how to clean the MICR mechanism.
