2.2OPERATIONAL PROCEDURE
The standard operating procedure for polishing the ferrules is shown below. The numbers on the right hand side of the diagram correspond to the explanations on the next page.
Check the condition of the ferrule
Polishing preparation Section 3
(1)
Prepare the polishing disk
Section 3.1
Prepare the polishing film
Section 3.2
Setting the thrust
Section 3.3
Polishing procedure Section 4
Mount ferrules
Remove adhesive (hand polish)
Grinding
Polishing
Finishing
Check polishing
Section 4.1
Section 4.2
Section 4.4
Section 4.4
Section 4.5
Section 4.6
(2)
(3)
Repolish
NG
Polishing complete
Maintenance Section 5
2 - 6
