4.3 ADJUSTING FIBER HOLDER
This section describes how to adjust the height of the fiber holder. This adjustment is done when mounting the holding jig onto the polishing unit. Refer to sections 4.4 and 4.5.
|
| Step 1 | Hang the looped fibers (which |
|
|
| have been tied into two |
|
|
| bundles) on the spool at the |
|
|
| end of the fiber holder (at the |
|
|
| lowest position). |
|
| Step 2 | Mount the holding jig onto the |
|
|
| polishing unit as described in |
|
|
| steps 4 and 5 of sections 4.4 |
|
|
| and 4.5. |
| Fiber holder | Step 3 | Loosen the clamping knob for |
|
|
| the fiber holder and slide the |
|
|
| fiber holder up so that the |
|
|
| fibers will not interfere with the |
|
|
| polishing. |
Weight | Fibers | Step 4 | Tighten the clamping knob to |
|
|
| clamp the fiber holder in place. |
Clamping knob | NOTE |
|
|
| |
| Always hang the fibers on the | |
| fiber holder so that they do not | |
| affect the weight. In this case | |
Polishing unit polishing may not | be done | |
| correctly because the | adaquate |
| polishing pressure is not applied | |
| to the holding jig. |
|
4 - 5
