Seiko Group OFL-12 SERIES, OFL-127001 Grinding 1ST Polishing and Polishing 2ND Polishing

4.4 GRINDING (1ST POLISHING) AND POLISHING (2ND POLISHING)

Weight

Weight arm lever

Rotation stop pin

Holding jig

Notch in holding jig

Rotation stop pin Thrust pin

Notch in holding jig

Step 1 Open the protection covers.

Step 2 Place the polishing film for grinding (green label) on the polishing disk, then set the weight position for grinding.

Step 3 Pull the weight arm lever toward you.

NOTE

Set the weight arm lever to the sown position with the protection covers open.

Step 4 Clean the polishing film using cleaning paper and water. Using the squeezable dropper bottle, wet the polishing film with about 2 ml of water.

NOTE

When you supply water, use the squeezable dropper bottle to avoid spilling water on the operation panel.

Step 5 Put the holding jig (after

completing the previous polishing step) onto the polishing film with the rotation stop pin in the notch in the holding jig.

Step 6 Lift the weight arm lever up, setting the thrust pin into the hole in the center of the holding jig.

4 - 6