Using the RS 220
Using the RS 220
To switch the product on and to listen to your audio source, proceed as follows:
Sequence of steps | Page | |
1. | Make sure that the rechargeable batteries are charged. | 14 |
|
|
|
2. | Switch your audio source on. | – |
|
|
|
3. | Switch your transmitter on. | 16 |
|
|
|
4. | Switch your headphones on. | 19 |
|
|
|
5. | Select the desired audio source. | 21 |
|
|
|
6. | Put on the headphones. | 15 |
|
|
|
7. | Adjust the desired volume on the headphones. | 23 |
|
|
|
Switching the transmitter on/off
Switching the transmitter on
Touch the Power touch key F.
The transmitter switches on. The LED of the last selected audio source (here COAXIAL) lights up. The ON LED G flashes until the transmitter has found suitable headphones and then lights up continuously.
ON
G
F
If the transmitter doesn’t receive an audio signal for more than 3 minutes, it switches, depending on the setting, to either standby mode or loop through mode. If the transmitter receivers an audio signal within the next 10 minutes, it automatically switches on again.