Adjustment tips for the operating menu

Activating/deactivating the automatic lock mode – “LOCK”

The transmitter has an autolock function (automatic lock mode) that can be activated or deactivated via the “LOCK” menu. When the autolock function is activated, the lock mode is automatically activated 10 seconds after pressing the last button. The lock mode protects the transmitter from accidental programming.

SET

DOWN UP

RF

RF

In the selection mode of the “LOCK” menu, press the multi-function switch (switch position SET).

The current setting of the autolock function is displayed.

Change the setting by sliding the multi-function switch to the position  (UP) or  (DOWN).

Select “LOC.ON” to activate the autolock function or select “LOC.OFF” to deactivate the autolock function.

Store your setting by pressing the multi-function switch (switch position SET).

Adjusting the output power – “POWER”

The transmitter features switchable output power. With reduced output power, the operating time increases.

In addition, you can also adjust the transmitter to “Low Intermodulation mode” (“LoI”). By so doing, the transmitter’s intermodulation performance is significantly improved, especially in multi-channel operation. In “Low Intermodulation mode”, the output power is reduced to 10 mW; the operating time will be about the same as using an output power of 50 mW.

Displaying the software revision – “SW--REV“

You can display the current software revision of the bodypack transmitter by calling up the “SW-REV“ menu item.

24