ASSEMBLY
ASSEMBLY
DEALER SETUP INSTRUCTIONS
The mower as recieved from the factory is partially assembled and requires minimum time to complete assembly and is ready for sale.
This mower is shipped vertically with shipping brackets. These shipping brackets are intended for use in transporting the mower from the factory to dealer.
DO NOT use these brackets to store the unit. DO NOT store mower vertically, the mower can
fall over resulting in serious injury or death. To avoid injury always store mower lying down on flat ground.
Assembly will be easier if comonents are aligned and loosely assembled before tightening hardware. Refer to bolt torque chart in Maintenance Section. All bolts are grade 5 unless otherwise specified.
A-FRAME ASSEMBLY-LIFT TYPE
1.Insert bushing (8) into lower end of each
2.Install bushing (15) between braces (3) through top rear hole of
3.Install bushing (11) between
4.Install Brace supports (4) to the rear lugs on the Main Frame with pivot pin(22) and retain with bolt (10) and locknut (6). Figure
Turbo120 01/11 | Assembly Section |
© 2011 Alamo Group Inc.