Sharp AL-1651CS manual 68

USER SETTINGS

Program		Setting codes
	Program name	(factory default	Explanation
number		setting appears
		in bold)

			•	The copy resolution in auto
				and text mode is normally 300
9	AE/TEXT	1: 300dpi		dpi. If high-quality copies are
	RESOLUTION	2: 600dpi		preferred, use this setting to
				change the resolution to 600
				dpi.
			•	If the memory fills up when
				two-sided copying is
				performed, "NORMAL" can be
	2-SIDED COPY	1: HI-SPEED		selected to make copying
10				possible. However,
	MODE	2: NORMAL
				"NORMAL" results in a slower
				copying speed. Normally "HI-
				SPEED" is selected to enable
				fast two-sided copying.
		1: 1/4"	•	Use this setting to set the
11	MARGIN WIDTH	2: 1/2"
		3: 3/4"		margin width.
		4: 1"
		1: 30%	•	Use this to change the
	MEM. FOR	2: 40%		proportion of machine
12		3: 50%
	PRINTER			memory used for printer
		4: 60%
				mode.
		5: 70%
			•	Use this setting to select
				whether or not holding down a
				key causes repeated input of
				the key. For keys that
				normally cause a set value to
13	AUTO KEY	1: ON		increase when held down (for
	REPEAT	2: OFF		example, holding down the
				[ ] key ( ) or [ ] key
				( )), this program can be
				used to have the set value not
				change when the key is held
				down.
			•	Use this setting to select how
		1: NORMAL		long a key must be pressed
				for the input to be accepted.
		2: 0.5 SEC.
14	KEY PRESS TIME	3: 1.0 SEC.		By selecting a longer time,
		4: 1.5 SEC.		you can prevent settings from
		5: 2.0 SEC.		being changed by the
				accidental pressing of a key.
	KEY TOUCH	1: LOW	•	This sets the volume of beep
15		2: HIGH
	SOUND			signals. (p.70)
		3: OFF

66