Sharp CD-XP160W PreparationUsefor, Setting the FM/AM span selector, Demonstration mode, 02/5/27

Setting the FM/AM span selector

￿The International Telecommunication Union (ITU) has established that member countries should maintain either a 100 kHz or a 50 kHz interval between broadcasting frequencies of FM stations and 10 kHz or 9 kHz for AM station. The illustration shows the 50/9 kHz zones (regions 1 and 3), and the 100/10 kHz zone (region 2).

Before using the unit, set the SPAN SELECTOR switch (on the rear panel) to the interval (span) of your area.

To change the tuning zone:

1Press the ON/STAND-BY button to enter the stand-by mode.

2Set the SPAN SELECTOR switch (on the rear panel) as follows.

z	For 100 kHz FM interval (10 kHz in AM)		100/10
	For 50 kHz FM interval (9 kHz in AM)	50/9

3Whilst pressing down the TUNER (BAND) button and the DISC SKIP button, press the ON/STAND-BY button until "CLEAR" ap- pears.

Caution:

This operation will erase all data stored in memory including clock, timer settings, tuner preset, and CD programme.

CD-XP160W

	Demonstration mode
The first time the unit is plugged in, the
unit will enter the demonstration mode.
You will see words scroll.
To cancel the demonstration mode:
When the unit is in the power stand-by mode (demonstration mode),
press the EQUALIZER/X-BASS/DEMO button. The demonstration
mode will be cancelled and the display will disappear.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the EQUAL-
IZER/X-BASS/DEMO button again.
Note:
When the power is on, the EQUALIZER/X-BASS/DEMO button can
be used to select the pre-programmed equaliser and extra bass
modes.			PreparationUsefor	- Systemconnections-
￿
	To turn the power on
Press the ON/STAND-BY button to turn the power on.
After use:
Press the ON/STAND-BY button to enter the power stand-by
mode.
￿			10
		02/5/27	CD-XP160W(SCA)E1.fm