Sharp CV-P09LX, CV-P10LC, CV-P10MX, CV-P12LX Installation in a sliding sash window, frame, proper length and attach it to the window, 4 Installframe.the window panel into the window

INSTALL WINDOW PANEL

Installation in a sliding sash window

(See page 12 for installation in a double-hung window.)

"A"

1 Connect the rain guards to the insect guard net.

Insert all three projections on each rain guard into the holes in the insect guard net.

Side “A” will now be uppermost, as indicated in the diagram.

Insect guard net

Hole

Projection

Rain guard

2 Attach the guard combined above to the window panel.

Push the insect guard net firmly to ensure that its four projections fit into the holes in the window panel.

Side “A” will now be at the top, as indicated in the diagram, when it is installed in the window.

Projection

Window panel

"A"

3	Cut the foam seal A (adhesive type) to the
	proper length and attach it to the window

frame.4 Installframe.the window panel into the window

If the inner height of the window is between 22" (559mm) and 24" (609mm) inclusive.

The window panel cannot be installed in windows less than 22" (559mm) high, as you will be unable to shut the exhaust cover.

(1)Remove the adjustment panel from the window panel, and cut the window panel to the same height as the window.

(2)Open the window sash and place the window panel on the window frame.

(3)Secure the window panel to the window frame with 2 screws.

Foam seal A (adhesive type)

Exhaust cover

Window

panelCut

Adjustment panel

Window panel

22"~24"

E-14