Sharp ER-A160, ER-A180 instruction manual Ñ3 ≈, Ñ4 ≈, Setting the date, Setting the time

ákey to take up

When using the take-up spool (using as journal paper):

• Insert the end of the paper into the slit in the spool. (Press the á key to feed more paper if required.)

• Wind the paper two or three turns around the spool shaft.

• If the holding plate is not attached to the spool, attach it by inserting the spool shaft into the large hole and sliding it into the small one.

• Set the spool on the bearing, and press the excess slack in the paper.

6. Replace the printer cover.

Hook the cover on the pawls on the cabinet and shut it.

• When using a paper roll as journal paper, you must change the printer type. Refer to “Programming print format” on page 30.

•You can use 2-ply journal/receipt paper. For the installation procedure, refer to Note on “Installing the paper roll” (page 39).

5

“PGM”.

Program Items as Necessary

Before programming, insert the manager (MA) key and turn the mode switch to			REG
		OPX/Z	MGR
			X1/Z1
	• On the key operation examples shown below, numeric such as 1234	PGM	X2/Z2
	indicates the number or parameter which must be entered using the
	corresponding numeric keys.

•On the receipt, the programmed data is printed together with header (date) and footer (e.g. consecutive number).

Setting the date

Enter day (one or two digits), month (two digits), and year (two digits) in this sequence.

Ñ3≈ Date (five or six digits) ÑÉ

Example: March 26, 2001

Key operation example

Ñ3 ≈

260301 ÑÉ

Print

Date (Day-Month-Year)

Setting the time

Set the time using the 24-hour format. For example, when the time is set to 2:30 AM, enter 230; and when it is set to 2:30 PM, enter 1430.

Ñ4≈ Time (max. four digits) ÑÉ

Example: 14:30

Key operation example

Ñ4 ≈

1430 ÑÉ

Print

Time (Hour-Minute)

8