Sharp ER-A180, ER-A160 View from rear, When not using the take-up spool using as receipt paper

3.Open the battery compartment cover located in front of the paper bed.

Press the tab toward you then pull and lift the cover to expose the battery compartment.

4.Install three new batteries in the battery compartment. Be sure that the positive (+) and negative (-) poles of each

battery are facing in the proper direction. When they are

correctly installed, ” symbol will disappear.

5.Close the battery compartment cover.

Battery compartment

cover

Tab

Paper bed

C A U T I O N !

View from rear

Incorrectly using batteries can cause them to burst or leak, possibly damaging the interior of the cash register. Note the following precautions:

•Be sure that the positive (+) and negative (-) poles of each battery are facing in the proper direction.

•Never mix batteries of different types.

•Never mix old batteries and new ones.

•Never leave dead batteries in the battery compartment.

•Remove the batteries if you do not plan to use the cash register for long periods. However, the data and user- programmed settings will be erased.

•If a battery leaks, clean out the battery compartment immediately, taking care to avoid letting the battery fluid come into direct contact with your skin.

•Do not throw any spent batteries into combustible waste and do not burn any spent batteries.

Your cash register comes with a battery caution label. Please cut off the appropriate half and attach it to the battery compartment cover.

4 Install the Paper Roll

Precaution: Be very careful for the manual cutter mounted on the printer cover when removing and replacing the cover, so as not to hurt yourself.

1.Turn the mode switch to the “REG” position.

2.Set the provided paper roll correctly and drop it in the paper bed.

3.Make a fold in the paper five centimeters from the end.

4.While press the ákey, insert the folded end straight into the paper inlet. The inserted end appears at the printing area.

5.When not using the take-up spool (using as receipt paper):

•Lead the end of the paper out through the manual cutter on the printer cover. (Press the ákey to advance the paper more if required.)

REG

OPX/Z MGR

X1/Z1 To the printer

X2/Z2

PGM

7