Sharp ER-A180, ER-A160 ≈î É, Programming an entry digit limit for , î, r and p keys

Key operation example	Print
0001 ≈		From left, ABCD
e É

Programming an entry digit limit for ', î, r and p keys

The limit is in effect for REG-mode operation but can be overridden in the MGR mode. When “0” is set, the operation of the corresponding key is prohibited.

			To program “0”
					≈	'îr, ,		or p
		Entry digit limit(0-8)
	To program for another key
Key operation example				Print
8 ≈î É							Entry digit limit

É

5Programming various functions

• Be very careful not to enter a wrong number for the number entry after the first Ñkey. Be sure to enter the number described in the "Procedure".

•You can continue programming until Ékey is pressed for the programming described in this section. To continue programming, repeat from the first numeric key entry.

Setting the register number

When your store has two or more registers, it is practical to set separate register numbers for their identification.

To set the register number “0”

Ñ1 ≈ Register number (one to three digits) ÑÉ

Key operation example Print

Ñ1 ≈

123 ÑÉ

Setting the consecutive number

The consecutive number is increased by one each time a receipt is issued.

			To begin the count from 0001
Ñ	2	≈		Ñ	É
			A number (one to four digits) that is one
			less than the desired starting number
Key operation example			Print

Ñ2 ≈

1000 ÑÉ

29