Preparation

Attaching the stand unit (for 60/70 inch models)

• Before attaching (or detaching) the stand, unplug the AC cord.	3 Insert the stand into the openings on the bottom	5 Attaching the stand cover.
• Before performing work, spread cushioning over the	of the TV (hold the stand so it will not drop from	1Insert the stand cover.
surface on which you will be laying the TV. This will	the edge of the base area).	2Insert and tighten the M4 screw (length:
prevent it from being damaged.	• Make sure that the stand is firmly inserted into the	8 mm) into the holes of the stand cover.
• Be sure that two or more persons attach the stand.	• Make sure that the stand is firmly inserted into the	8 mm) into the holes of the stand cover.
• Be sure that two or more persons attach the stand.	TV. Improper installation may result in tilting of the	• Tighten the screw by pressing the bottom of the
CAUTION	TV. Improper installation may result in tilting of the	• Tighten the screw by pressing the bottom of the
CAUTION	TV set.	stand base to the TV side.
• Attach the stand in the correct direction.	Soft cushion	M4 screw
• Be sure to follow the instructions. Incorrect installation	Soft cushion	M4 screw

of the stand may result in the TV falling over.
• After attaching the stand to the TV, do not hold the
stand when you put up, set up, move or lay down the TV.
• Do not remove the stand from the TV unless using a
wall mount bracket to mount it.
1 Confirm that there are 9 screws (four M6 screws,
four M5 screws and one M4 screw) supplied
with the stand unit.

	2 Attach the supporting post to the stand base.	4 Insert and tighten the M5 screws (length: 14 mm)
	1Insert the claws of the supporting post into	4 Insert and tighten the M5 screws (length: 14 mm)
	the stand base.	into the holes on the rear of the TV.
	2Secure the post and the base using the M6	M5 screws
	screws (length: 16 mm) and a screwdriver.	M5 screws
	screws (length: 16 mm) and a screwdriver.
	M6 screws

NOTE

•To detach the stand unit, perform the steps in reverse order.

•A screwdriver is not supplied with this product.

•In the installation procedure, be careful not to catch your fingers between the TV set and the floor.

•The TV can be rotated up to 20 degrees to the right and left.

NOTE

• Tighten the screws to the holes of the mark “b”.