Adjusting the screen display
For analog signal
1.First perform an automatic adjustment. (p. 15)
2.Perform manual adjustment where necessary. (p. 16)
For digital signal
The monitor can generally be used without adjustment. If necessary perform manual adjustment. (p. 19)
Note:
-All adjustments will be saved even after turning the power off.
Resetting all adjustment values
All adjustment values can be returned to their origi- nal
1.Turn off the monitor power.
2.Press the MENU button and the SELECT button simultaneously, and while doing this press the power button (i.e. turn the power on). When [ALL RESET] appears on the screen, the reset is complete.
Note:
-While ALL RESET is displayed, the control buttons are disabled.
-It is not possible to reset values when the adjustment lock is in place. Remove the adjustment lock before attempting to operate control buttons.
Adjustment lock function
By disabling the control buttons (i.e. setting the lock) any attempted changes to adjusted values will be voided.
1.Turn off the monitor power.
2.While pressing the MENU button, press the power button (i.e. turn the power on).
Continue to press the button until the message appears on the screen.
When the menu is unlocked: [ADJUSTMENT LOCKED] will appear on the screen, and the lock will be set.
When the menu is locked:
[ADJUSTMENT UNLOCKED] will appear on the screen, and the lock will be removed.
Note:
-When the lock is in place, all buttons other than the power button are disabled.
Adjusting the backlight
The backlight brightness can be adjusted. Carry out the commands without the On Screen Display (OSD) Menu displayed. If the OSD Menu is displayed, press the MENU button (several times may be required) and begin when the OSD Menu has disappeared.
1.Without the OSD Menu being displayed, push the 
or the 
button. At the bottom of the screen the BRIGHT bar will appear.
2.Adjust by pressing the 
button (darker) or 
button (lighter).
The BRIGHT bar automatically disappears several seconds after the last command.
14
