Adjusting the screen display (With analog connection)
Manual screen adjustment | ADJUSTMENT Menu |
|
Adjustments can be made using On Screen Display (OSD) Menu provided.
On Screen Display for adjustment
If you are using Windows, open the Adjustment Pattern on the accompanying Utility Disk. (p. 15).
If your system is not Windows, you can not use the Adjustment Pattern. Therefore display an image that makes the entire screen light and adjust it through checking visually its actual tone.
This chapter provides the procedure how to adjust the screen by using Adjustment Pattern (for Win- dows)
How to adjust
1.Press the MENU button.
The ADJUSTMENT Menu will be displayed.
At this point relevant menu options can be adjusted.
Each time the MENU button is pressed the next menu is selected. (ADJUSTMENT → GAIN CONTROL → WHITE BALANCE → MODE SELECT → OSD Menu disappears)
Notes:
-The OSD Menu automatically disappears several seconds after the last command.
MANUAL: Individual menu options are manually adjusted.
AUTO: Every menu option is automatically adjusted.
Notes:
-Press the 
button to select [AUTO].
-To choose a menu option:SELECT button
-To go to the next menu: MENU button
CLOCK
The figure below demonstrates how to adjust so that
vertical flicker noise is not emitted. (
buttons)
Vertical flicker noise
PHASE
The figure below demonstrates how to adjust so that
horizontal flicker noise is not emitted. (
buttons)
Note:
-Adjustments to PHASE should be made only after CLOCK has been correctly set.
Horizontal flicker noise
H-POS (horizontal positioning) and V-POS (vertical positioning)
To center the screen image within the boundaries of the screen, adjust the
the 
buttons)
Screen frame
16
