Marantz SR7001, SR8001 Setup, Setting the Macro Interval Time, Adjusting the Display Contrast

ENGLISH		• If the copying fails in the middle of the
		copying process, ERROR is displayed on
		the remote control.
		Check and perform steps 1 to 7 again.
	11. Once copying is completed, press the M button
		on both remote controls.
		SETUP
	SETTING THE LIGHTING TIME
	•	The LCD lights up when the LIGHT buttons are
		pressed. The LCD remains lit while the pressed
		button is held down, and it goes off when the
		button is released.
	•	The LCD continues to light up if another button
		is pressed while it is lit or if pressed within two
		seconds after the light goes off.
	•	The lighting time can be set in one-second units
		from 0 to 60 seconds.

The LIGHT buttons have light-absorbing properties that enable them to store light. If the buttons are no longer illuminated in a dimly lit environment, bring the buttons near a fluorescent lamp or other light source for a sufficient amount of time. This should illuminate the buttons again.

•The LIGHT buttons consist of a LIGHT1 and LIGHT2 button, and they both perform the same operation.

The factory default lighting time is set to 15 seconds.

This example shows how to set the lighting time to 20 seconds.

2	3						4
		LEARN						LEARN
PAGE 1	2		1	2	3	4		1	2	3	4

1. Hold down the M button for three seconds or more.

The menu is displayed.

2. Press the > button to display the second page SETUP menu.

3. Press the D1 (LIGHT) direct button . The LIGHT is displayed on the LCD

4. Press the 3 or 4 cursor button to set the lighting time.

5. Press the OK cursor button to enter the lighting time.

6. Once the setting is finished, press the M button.

SETTING THE MACRO INTERVAL TIME

When a macro program is executed, control signals are transmitted in sequence. This transmission interval (interval time) can be set in 0.5-seconds units from 0.5 to 5 seconds.

If the interval time is set in this Setup mode, the interval times for all programmed macros are changed. If necessary, use EDIT (see page 64) in the macro program to change the individual transmission times.

The factory default setting for the transmission interval is 1 second.

This example shows how to set the interval time to 5 seconds.

2	3						4
		LEARN						LEARN
PAGE 1	2		1	2	3	4		1	2	3	4

1. Hold down the M button for three seconds or more.

The menu is displayed.

2. Press the > button to display the second page SETUP menu.

3. Press the D2 (I-TIME) direct button.

4. Press the 3 or 4 cursor button to set the interval time.

Holding down the cursor button fast-forwards the time indicator.

5. Press the OK cursor button to enter the interval time.

6. Once the setting is finished, press the M button.

ADJUSTING THE DISPLAY CONTRAST

The contrast of the LCD can be adjusted. Adjust for maximum visibility according to your viewing environment.

2	3						4
		LEARN						LEARN
PAGE 1	2		1	2	3	4		1	2	3	4

1. Hold down the M button for three seconds or more.

The menu is displayed.

2. Press the > button to display the second page SETUP menu.

3. Press the D3 (CONT) direct button .

4. Press the 3 or 4 cursor button and set the display contrast for maximum visibility.

The adjustment has 10 levels.

The factory default setting for the contrast is the fifth level.

5. Press the OK cursor button to enter the display contrast.

6. Once the setting is finished, press the M button.

66