Transit, Installation (using) environment, Note
1. Installing (use) conditions
Before installing the machine, check that the following installing (use) conditions are satisfied.
(3)Power frequency, waveform
ρThe frequency must be within the range of the specified frequency 2%. If power waveform is deformed, a trouble may occur.
If the installing (use) conditions are not satisfied, the machine may not display full performances, resulting in troubles. It may also cause safety problems. Therefore, be sure to arrange the installing (use) conditions before setting up the machine.
No. | Content |
1Transportation space
2 Installing space
3 Power source (Capacity, fluctuation, safety)
4 Floor strength
5 Direct rays of the sun, dust, temperature, humidity, gases, chemicals
A.Transportation space
For installation of a large size machine, be sure to check that the door size is wide enough before bringing in.
B. Installing space
The following space must be provided around the machine in order to assure machine performances and proper operations.
If any option is installed, provide the additional space for installing it.
Adequate space must be provide behind the machine for proper ventilation heat and dust. If not, the machine cannot exhibit func- tions against heat and dust, causing some troubles.
(30CM)
| |
| (30CM) | (45CM) |
C.Power source (Capacity, voltage, frequency, safety, plug)
If the power specifications are not satisfied, the machine cannot exhibit full performances and may cause safety trouble.
Strictly observe the following specifications.
(1) Power capacity
Check that the following power capacity is satisfied. If not, addition- ally provide a power source.
Current capacityJapan: 20A or more
EX 100V: 15A or more
EX 200V: 10A or more
Check the shape of the power plug of the machine, and insert it into a power outlet of the acceptable shape.
(2) Power voltage
Measure the voltage during copyingρ to check that the voltage is in the range of the specified voltage 10%.
If the voltage is outside the specified range, please have a certified electrician upgrade the outlet.
(An electrical work is required.)
Use of a
(4)Safety
Be sure to properly ground the machine.
Grounding (earth connection) must be performed before inserting the power plug into the power outlet.
When disconnecting the earth connection, be sure to disconnect the power plug from the power outlet in advance.
(5)Power plug
Check the shape of the power plug of the machine, and insert it into a power outlet of the acceptable shape.
Power plug stated in power capacity.
D. Floor strength and level
This machine is considerably heavy and becomes heavier with an option installed.
The floor must be strong enough to safely support the weight of the machine as well as any installed options.
If the unit is not horizontally installed, the toner density control is not performed normally, degrading the copy quality.
If not, color shift or image distortion may occur.
To assure proper Image quality, make sure the machine is setting level.
E.Direct rays of the sun, dust, temperature, humidity, gasses, chemicals, vibration
(1)Temperature and humidity (Environmental conditions)
This machine is designed to perform properly under the specified temperature and humidity. If the temperature and humidity exceeds the specified range, the machine may not operate properly and or cause equipment failure.
Especially when the humidity is too high, paper absorbs humidity to cause a paper jam or dirty copy.
Do not install the machine near a heater, a cooler, or a humidifier.
Condensation may form inside the machine causing multiple trou- bles. Use enough care for ventilation.
