Sharp MX-3500N Placing The Original On The Document Glass, Open the automatic document feeder

PLACING THE ORIGINAL ON THE DOCUMENT GLASS

This section explains how to place the original on the document glass.

Allowed original sizes

Maximum original size

Standard sizes

A3: 297 mm (width) x 420 mm (length) 11" (width) x 17" (length)

Non-standard sizes

297 mm (width) x 432 mm (length)

When a non-standard size original is placed in copy mode, see "SPECIFYING THE ORIGINAL SIZE" in the Copier Guide.

When a non-standard size original is placed for a fax or scanner transmission, see "SPECIFYING THE SCAN SIZE OF THE ORIGINAL" in the Facsimile Guide or Scanner Guide.

Open the automatic document feeder.

1

Place the original.

Place the original face down in the far left corner of the document glass.

Original size detector

2

Document glass scale

mark

A5 or

5-1/2" x 8-1/2"

B4 or

B5 8-1/2" x 14"

A4 or 8-1/2" x 11" A3 or 11" x 17"

Document glass scale

mark

B5R

A4R or 8-1/2" x 11"R

The original should always be placed in the far left corner, regardless of the size.

Align the top left corner of the original with the tip of the mark.

• Do not place any objects under the original size detector.

Closing the automatic document feeder with an object underneath may damage the original size detector and prevent correct detection of the original size.

•If you are placing a small original on the document glass, it is convenient to place a blank sheet of A4 or B5 (8-1/2" x 11" or 5-1/2" x 8-1/2") paper on top of the original.

Close the automatic document feeder.

3

36