24
Controlling the Projector by a Computer
When the RS-232C terminal on the pro jector is connected to a com puter with an RS-232C serial
control cable (cross type, co mmercially available), the co mputer can be used to control t he
projector and check the statu s of the projector. Refer to the “SETUP M ANUAL” contained on the
supplied CD-ROM for “RS-232C Spe cifi cations and Commands”.

When connecting to a co mputer using an RS-23 2C serial control ca ble

RS-232C serial control cable (cross type, c ommercially available)
Computer
To RS-232C terminal
To RS-232C terminal
The RS-232C function may not operate if you r computer terminal is not c orrectly set up. Refer to the
operation manual of the computer for d etails.
Refer to pages 2 to 9 of the “SETUP MANUAL” contained on t he supplied CD-ROM for “Con necting
Pin Assignments” and “RS-232C Speci fi cations and Commands”.
•
•
Note
Info
Do not connect the RS-232C cable to a por t other than the RS-232C terminal on t he computer. This
may damage your computer or projector.
Do not connect or disconnect a n RS-232C serial control cable to or f rom the computer while it i s on.
This may damage your computer.
•
•