Sharp PGLW2000, PG-LW2000 appendix Appendix, 53, 54, 54, 57, 19-22, the projector illuminates

Problem	Check	Page
Maintenance indicator on	• See “Maintenance Indicators”.	54
the projector illuminates
or blinks in red.
Picture is green on	• Change the input signal type setting.	41
COMPUTER (YPbPr)/
HDMI (YPbPr)
Picture is pink
(no green) on
COMPUTER (RGB)/
HDMI (RGB)
Picture is too bright and	• Image adjustments are incorrectly set.	39
whitish.
The cooling fan becomes	• When temperature inside the projector increases, the cooling fan runs	8, 9
noisy.	faster.	53, 54, 55
The lamp does not light	• The lamp indicator is illuminating in red.	54, 57, 58
up even after the	Replace the lamp.
projector turns on.
The lamp suddenly turns
off during projection.
The image sometimes	• Cables are incorrectly connected to the projector or the connected	19–22
fl ickers.	equipment works improperly.
	• If this happens frequently, replace the lamp.	57
The lamp needs much	• The lamp will eventually need to be changed.	57
time to turn on.	While the remaining lamp life draws to a close, replace the lamp.
Picture is dark.
The remote control	• Operate the remote control while pointing it at the projector's remote	13
cannot be used.	control sensor.
	• The remote control may be too far away from the projector.
	• If direct sunlight or a strong fl uorescent lamp is shining on the
	projector's remote control sensor, place the projector where it will not
	be affected by strong light.
	• The batteries may be depleted or inserted incorrectly. Make sure the	13
	batteries are inserted correctly or insert new ones.

Appendix

67