Connecting the Projector
Connecting a computer to the projector using the
Connections& Setup |
Computer RGB cable
PC audio cable
Projector
3
1 | |
|
Computer RGB cable
1Connect one end of the supplied computer RGB cable using the supplied
VGA cable to the
2Connect the other end of the computer RGB cable or
the VGA side of the
3 To use the
4Connect the other end to the audio output terminal on the computer.
Projecting the image
When connecting with this method, press INPUT on the remote control or the projector and select the input signal type to INPUT 1 Computer/Analog RGB.
CAUTION
•Before connecting, be sure to turn both the projector and the computer off. After making all connections, turn the projector on first. The computer should always be turned on last.
•Please read the computer’s operation manual carefully.
•Refer to page 53 “Computer Compatibility Chart” for a list of computer signals compatible with the projector. Use with computer signals other than those listed may cause some of the functions not to work.
•A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Sharp Authorized Projector Dealer or Service Center.
PC audio cable | 4 | ||||||||||
|
| ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
2
Computer
Connecting other compatible computers
When connecting the projector to a compatible computer other than an
•Connecting computers other than the recommended types may result in damage to the projector, the computer, or both.
“Plug and Play” function
•This projector is compatible with
•Before using the “Plug and Play” function, be sure to turn on the projector first and the connected computer last.
•The DDC, Plug and Play function of this projector operates only when used in conjunction with a VESA DDC compatible computer.
14
