How to install the monitor
Mounting precautions
•Since the monitor is heavy, consult your dealer before installation.
•Installing or moving the monitor must be done by three or more people.
•Do not hold the LCD panel when moving the monitor. This may cause product damage, failure, or injury.
•Install the monitor with the surface perpendicular to a level surface. If necessary, limit the tilt between 0 and 20 degrees downward.
•Mounting the monitor on the wall requires special expertise and the work must be performed by an authorized SHARP dealer. You should never attempt to perform any of this work yourself. Our company will bear no responsibility for accidents or injuries caused by improper mounting or mishandling.
•This monitor should be used at an ambient temperature between 32°F(0°C) and 104°F(40°C). Provide enough space around the monitor to prevent heat from accumulating inside.
Unit: inch[cm]
The Power LED must be on the lower side.
If it is diffi cult to provide such space because the monitor is installed inside a housing or for other reasons, take other measures to keep the ambient temperature between 32°F(0°C) and 104°F(40°C) such as installing a fan in the housing.
•This monitor must be installed in a vertical orientation only. It cannot be installed in a horizontal orientation.
•Do not block any ventilation openings. If the temperature inside the monitor rises, this could lead to a malfunction.
•After mounting, it is recommended to take some measures to prevent the monitor from falling down. Secure the monitor by fastening the hooks at the top of the monitor to a wall or a pillar with strong cord and brackets (not included).
•Do not place the monitor on a device which generates heat.
•Be sure to use a stand or a
•This monitor is designed to be installed on a concrete wall or pillar. Reinforced work might be necessary for some materials such as plaster / thin plastic board / wood before starting installation. This monitor and bracket must be installed on a wall which can endure at least 4 times or more the weight of the monitor. Install by the most suitable method for the material and the structure.
•This monitor is fi xed to the temporary stand when shipped from the factory. Please note that this stand is for temporary use only until the monitor is properly mounted.
E10