Sharp XL-UH220H Remote control, Battery installation, Test of the remote control, Battery removal

Remote control

XL-UH220H

Battery installation

Use 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar).

Batteries are not included.

1Open the battery cover.

2Insert the batteries according to the direction indicated in the battery compartment.

When inserting or removing the batteries, push them towards the battery terminals.

3Close the cover.

Precautions for battery use:

Replace all old batteries with new ones at the same time. Do not mix old and new batteries.

Remove the batteries if the unit will not be used for long periods of time. This will prevent potential damage due to battery leakage.

Caution:

Do not use rechargeable batteries (nickel-cadmium battery, etc.). Installing the batteries incorrectly may cause the unit to malfunction.

Battery removal:

Open the battery cover and pull up the battery to take out.

Notes concerning use:

Replace the batteries if the operating distance is reduced or if the operation becomes erratic.

Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth.

Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs.

Keep the remote control away from moisture, heat, shock, and vibrations.

Test of the remote control

Check the remote control after checking all the connections (see pages 8 - 10).

Point the remote control directly at the remote sensor on the unit.

The remote control can be used within the range shown below:

Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy music.

Preparation for Use

11