Installation and Commissioning | Lindy Carbon Monoxide Alarm

3	NSTALLATION AND COMMISSIONING
	I
	INSTALLATION AND COMMISSIONING
3.2	19'' installation	When installing the RMS in a rack, the additional requirements in
		accordance with IEC 950 must be observed and complied with!
		• Determine the position in which the RMS is to be located within the
		19" rack. Observe the existing number of blanking plates for a uni-
		form rack appearance.
	Caution!	Danger of overheating!
		Allow sufficient space from built-in fans or air-conditioners to
		ensure an unimpeded flow of air in the rack.hten.

Note	• Mount the RMS on sliding rails if possible.
	This makes handling the device easier and reduces wear on the rack.

If the RMS is mounted freely suspended, hold the device horizontally when tightening the screws and start with the two bottom screws.

•Mount the RMS in the desired position with 4 mounting screws, washers and nuts.

Rack

Image 12

Lindy Carbon Monoxide Alarm user manual Installation and Commissioning

Contents

MonitoringRack MonitoringSystemSystem Rack Ccontentsontents Ccontentsontents General Information Safe Working Warranty Lapse of warrantyDisposal Service HotlineMail STANDARDS, Regulations Rack Monitoring Lite Connection options DigitalHumidity Sensor digital Mains Power Strips Door ContactReader Infrared Room surveillance Preparations Check the supplied itemsNecessary Tools Installation and Commissioning Electrical Installation Connections and cablingCabling Mains montoring Digital AlertUPS 10BASET COM AUX Fuses Double -pole fuse / fuse of the neutral wire Fuse for the auxiliary voltageSupply Commissioning Operator Control Elements Initial State Operation VIA Keys on the Front of the Device Selecting a menu item Filter messages Display in the Confirm menuEntering network parameters Operation VIA Telnet or Serial Interface COM ? Help Block diagram Network Configuration IP Address Snmp Configuration AMESnmp a Ccess Write Community Reboot Configuration VIA Tftp Update VIA TftpTFTP-SERVER Status User Administration Selection pointer to next user Configure digital outputs Digital Outputs Invert Temperature Inputs Digital InputsQuit Humidity Inputs Mains Monitoring Update the screen AUX Device Selection Previous Device+ Next Device Return Quit With Saving Filter Filter Selection UITSnmp Trap Ffect LED W Arning DIGITAL/ALERT/UPS Inputs TEMPERATURE/MAINS/HUMIDITY Inputs ODE-A B M ODE-BSet threshold Selection pointer to next input Feedback Inputs Previous Feedback InputIlter Message LOG Preconfigured filters with an Example of filter configuration using filter 1 temperatureExamples of filter settings Example of terminal assign MonitoringRack MonitoringSystemSystem Rack Eexamplexample Configurationconfiguration Specimen output Configuration Rack Mmalfunctionsalfunctions Remedy Technicaltechnical Datadata Rated ambient temperature FAQ EMCMIB RFC Product designation Model System Configuration Documentation Explanation of the MIB For RMSIso.org.dod.internet.private.enterprises.infratec.rms Variable Type Value Objects under Variable Type Value Access Object under ups I NT Able Variable Type Value AccessObjects under Variable Type Value Objects under outputTable Variable Type Value Objects underObjects under tempTable Objects under humidTable Objects under mainsTable Variable Type Value Objects under filterTable Variable Type ValueObjects under Variable Variable Type Value Access 6.1.4.1.1909.10.7.3 Type Value Access FilterMainsTable Objects under userTable Variable Type Value Objects under aux VariableObjects under icc Variable Type Value GNU General Public RemoRack RMS Lite RMS Advanced Rack