6
MMALFUNCTIONSALFUNCTIONS
Caution | If, during operation, the “Power” LED goes out or smoke or an abnor- |
| mal smell is ascertained, |
| • Unplug the power cable. |
| • Please contact your dealer. |
In the event of malfunctions | • Check whether your system is properly set up (> 3). |
System no longer starts. | Cause: Current operating software faulty. |
Remedy:
•Ensure that a correctly configured (> 4.1.2 ) terminal is connected to the COM interface on the front of the device or on the back.
•Press the Reset key on the front of the device with a pointed object. The device will reboot.
The following boot messages appear on the terminal screen:
| (c) |
| |||
| Memory Test : 00004096k Ok |
| |||
| Status of IDE : Ok |
|
| ||
| Drive 0 : MZX023157, (C/H/S) : 123/2/32 |
| |||
| Drive 1 : Not detected. |
|
| ||
| Probing... | [NE*000] |
|
| |
| NE*000 base 0x0300, addr 00:10:6C:00:04:41 |
| |||
| LILO |
|
|
| |
|
| ||||
| RMS - Rack Monitoring System |
| |||
| System is ready to boot. You may choose your old image |
| |||
| by | pressing 'o'. |
|
| |
|
| ||||
| boot: <TAB> |
|
| ||
| r |
|
| ||
| boot: o | <ENTER> |
|
| |
| Loading | o |
|
| |
| Linux version 2.1.97 (root@PC14) (gcc version 2.7.2.1) #7 |
| |||
| SMP Tue May 5 10:26:58 |
|
| ||
| Calibrating delay loop... | 3.70 BogoMIPS | 45 | ||
| • If, during the boot: display, the keys o and Return on the terminal |
| |||
| keyboard are pressed, the system boots with the last valid operating |
| |||
| software (otherwise it boots again with the current version, which is |
| |||
| faulty here). |
|
| ||
The “Fault” LED lights up, the | • Load the current operating software from the Internet and update |
| |||
sensors do not work, “Overload” | the system(> 4.4.3). |
|
| ||
is displayed in the LCD display. | Cause: Auxiliary voltage interruption in connection with overload or |
| |||
|
| ||||
| short circuit in the sensor cable. |
|
| ||
| Remedy: |
|
|
| |
If the malfunction still occurs after | • Confirm the “Overload” message in the LCD display with the ENTER key. |
| |||
• Remove the overload or short circuit. |
| ||||
performing the remedial measures | • Switch the auxiliary voltage back on in the “Aux.Volt.”(>4.3) menu |
| |||
| with the ENTER key. |
|
| ||
| • Please contact technical support (> 1.4) or your dealer. |
| |||
MonitoringRack MonitoringSystemSystem
