
Using the Kensington Lock
This projector has a Kensington Secu- | Rear View | |
rity Standard connector for use with a | ||
Kensington MicroSaver Security Sys- |
| |
tem. Refer to the information that came | Kensington Security | |
with the system for instructions on how | ||
Standard connector | ||
to use it to secure the projector. | ||
|
Troubleshooting
Problem | Check |
|
|
No picture appears. | • Projector power cord is not plugged into the wall outlet. |
| • Selected input is wrong. (See page 31.) |
| • Cables incorrectly connected to back panel of the projector. (See pages |
| |
| • “Contrast” and “Bright” adjustments are set to minimum position. (See |
| page 44.) |
|
|
Color is faded or poor. | • Picture adjustments are not correct. (See page 44.) |
|
|
Picture is blurred. | • Adjust the focus. (See page 25.) |
| • Projection distance is too long or too short to allow for proper focus. (See |
| pages 26 and 27.) |
|
|
No OSD appears. | • OSD Display is set to “OFF”, preventing to display some or all |
| Displays. (See page 51.) |
|
|
An unusual sound is | • If the picture is normal, the sound is due to cabinet shrinkage caused by |
occasionally heard from the | temperature changes. This will not affect operation or performance of the |
cabinet. | projector. |
|
|
Maintenance indicator | • Refer to “Maintenance Indicators” on page 58. |
illuminates. |
|
|
|
Picture noise appears. | • Adjust the “Phase” setting. (See page 48.) |
|
|
Image is green on INPUT 2 | • Change the input signal type. (See page 52.) |
Component. |
|
Image is pink (no green) on |
|
INPUT 2 RGB. |
|
|
|
For SHARP Assistance (U.S.A. only)
If you encounter any problems during setup or operation of this projector, first refer to the “Troubleshooting” section on this page. If this operation manual does not answer your ques- tion, please call toll free
Our World Wide Web address is http://www.sharpusa.com/ .
Appendix
-63