Operations
ENGLISH | LISTENING TO A PROGRAM SOURCE | |
Before operation | ||
|
Enter the standby mode. | POWER |
ON/OFF |
The STANDBY indicator lights up. This means that the receiver is not disconnected from the AC mains and a small amount of current is retained to support the memorized contents and operation readiness.
To switch the power off, push the POWER switch again.
Then the power is cut off and the STANDBY indicator goes off.
In the standby mode, turn the power on.
1
INPUT SELECTOR
or |
| POWER |
VIDEO | or |
|
AUDIO |
|
|
CD | TUNER | VCR 1 |
AUX | TAPE MON. VCR 2 | |
6CH DIRECT | DVD/TV | |
| INPUT |
|
| SELECTOR |
Each time the POWER button on the remote control is pressed, the receiver is turned on to enter the operating mode or off to enter the standby mode.
In the standby mode, if the INPUT SELECTOR button is pressed, the receiver is turned on automatically and the desired input is selected.
Switch the speakers on.
2 | SPEAKER |
ON/ OFF
Then sound can be heard from the speakers connected to the speaker terminals.
When using headphones for private listening, press the SPEAKER switch again to switch the speakers off.
Select the desired input source.
3 | INPUT SELECTOR | CD | TUNER VCR 1 |
| VIDEO | or |
|
| AUDIO | AUX | TAPE MON. VCR 2 |
|
|
DVD/TV
TAPE MONITOR
Each time the “AUDIO” button is pressed, the input source changes as follows;
TUNER CD AUX (frequency display)
Each time the “VIDEO” button is pressed, the input source changes as follows;
VCR1 VCR2 DVD
When the TAPE MONITOR button is set to on so that “TAPE M” indicator lights up, other inputs can not be heard from the speakers.
To listen to a input source other than TAPE MONITOR, be sure to set the TAPE MONITOR button to off.
TAPE MONITOR function
You can connect either a tape deck or a graphic equalizer to the receiver’s TAPE MONITOR jacks.
To listen to the component connected to these jacks, set the TAPE MONITOR button to on.
If you connect a
For further details, refer to the operating instructions of the component connected.
When selecting the 6 CH DIRECT as desired,
displayed and the 6
separate analog | 6 CH |
|
DIRECT |
| |
|
| |
signals from 6 CH |
|
|
decoder connected to | or | 6CH DIRECT |
|
this unit pass through the tone (bass, treble)
and volume circuits only and directly transfer to the speakers. (In case that the TAPE MONITOR button is set to on, the TAPE MONITOR button is automatically set to off.)
To cancel the 6 CH Direct function, press the 6 CH DIRECT button or select the desired input source. These 6 separate analog signals can be heard only, not recorded.
10