Sherwood RVD-6090R operating instructions Downmixing into 2 front channels, English

In the surround modes except for the normal stereo mode, adjusting

When the distances from the prime listening position to front left, center, front right, rear left and rear right speakers are same, the basic settings are as follows according to the surround modes;

In the Dolby Digital(AC-3) mode

Center delay time : 0 ms, Rear delay time : 0 ms

In the Dolby Pro Logic, Theater, Hall 1 and Hall 2 modes Rear delay time : 15 ms

If the center or the rear speaker(s) is(are) not at the same distance from the prime listening position as the front speakers, increase or decrease the center delay time by 1 ms for every about 30 cm(1 foot) it is closer or farther away and increase or decrease the rear delay time by 5 ms for every about 1~1.5 m(3~5 feet) it is closer or farther away.

Check the delay time to be adjusted.

13

D.TIME

The delay time will be displayed for 5 seconds. The corresponding delay time is displayed. The center delay time can only be adjusted in the Dolby Digital (AC-3) mode.

When playing Dolby Digital (AC-3) program sources in the THEATER, HALL 1 or HALL 2 modes, the center and rear delay times can be adjusted just as they are in the Dolby Digital (AC-3) mode.

ENGLISH

Adjust the delay time.

14

ADJUST

Each time this button is pressed, the delay time changes in regular intervals.

If the delay time disappears, start from the step 13 again.

Memorize the delay time.

15

D.TIME

The rear delay time can be memorized without pressing the DELAY TIME button.

In Dolby Digital(AC-3) mode, repeat

16 the above steps 14 and 15 to adjust the rear delay time.

Downmixing into 2 front channels

Allows the multi-channel Dolby Digital(AC-3) signal to be reproduced through only two speakers or through headphones.

When playing the Dolby Digital(AC-3) program sources, press the STEREO button.

STEREO

or STEREO

“ST” and the Dolby Digital(AC-3) indicators light up, meaning it enters the 2-CH downmix mode, and then the 5 discrete channels(front L, center, front R, rear L and rear R) are mixed down to 2 front channels.

To cancel the 2-CH downmix mode, select the desired surround mode.

When play is stopped or interrupted, etc., the 2-CH downmix mode is not canceled even though “ST” and the Dolby Digital(AC-3) indicators goes off.

If the headphones are plugged and the SPEAKER switch is set to off while playing the Dolby Digital (AC-3) program sources, it will enter the 2-CH downmix mode automatically(but only the Dolby Digital(AC-3) indicator lights up still) and if the headphones are unplugged and the SPEAKER switch is set to on in the 2-CH downmix mode, it will return to the previous mode.

17