Shure manual DP11EQ Hardware, Overview, Front Panel, Back

DP11EQ HARDWARE

Overview

Front Panel

		DATA
Ê ￿ ￿	￿	￿ ￿
Ê BYPASS Button and LED. Press this button to	￿ Dynamic Gain Meters. The 7 red LEDs on the left

suspend all signal processing from the audio path. When the LED illuminates, the dynamics processor, delay, and the equalizers are bypassed.

indicate the reduction in dynamic range, while the three yellow LEDs on the right indicate dynamic boost.

￿

￿

SIGNAL LED. Illuminates when input signal is	￿ DATA LED. This LED indicates that the computer
	is communicating with the unit via the RS-232 port.
present. Intensity varies with input signal level.
CLIP LED. Illuminates when the input signal is	￿ POWER LED. LED illuminates when unit is
within 6 dB of clipping.	powered on.

Back

Ê ￿ ￿

ÊPower Connector with Integral Fuse. Connects to AC power. The fuse is located in the drawer below the connector.

￿9-PinRS-232 Port. Connects the unit to a computer. For use with DP11EQ software and for DSP firmware upgrades.

￿Shure Link Interface. Allows linking of up to 16 Shure Link compatible devices which may be accessed by a single computer.

￿DIP Switches. See DIP Switches.

￿ ￿ ￿

￿Output ConnectorÐ1/4-Inch & XLR. Active, cross-coupled, balanced outputs can be used with balanced or unbalanced inputs. Can be switched

between +4 dBu/±10 dBV line-level operation by DIP switch. 1/4-Inch and XLR are driven independently and either can be balanced or unbalanced without affecting the other.

￿Input ConnectorÐCombined XLR and

1/4-Inch.Active balanced input can be used with balanced or unbalanced outputs. Can be switched between +4 dBu/±10 dBV line-level operation by DIP switch.

English ± 3