Siemens NCM S7 appendix 8F3AH, 8F7FH

Programming FCs (Functions) and FBs for S7 Ethernet CPs

Note

For entries coded with 8FxxH in STATUS, refer to the information in the STEP 7 Standard and System Functions reference manual. The chapter describing error evaluation with the RET_VAL output parameter contains detailed information.

To find out which SFCs are used and are relevant for error evaluation, display the properties dialog of the FC described here in the “Calls” tab.

Table 6-2 AG_SEND / AG_LSEND Codes

DONE	ERROR	STATUS	Meaning
1	0	0000 H	Job completed without error.
0	0	0000 H	No job being executed.
0	0	8181H	Job active.
0	1	7000H	This code is possible only with the S7-300: the FC was called
			with ACT=0; the job has not yet been processed.
0	1	8183H	No configuration or the ISO/TCP service has not yet started on
			the Ethernet CP.
0	1	8184H	System error.
0	1	8185H	LEN parameter longer than SEND source area.
0	1	8186H	ID parameter invalid. ID!=1,2 to 64.
0	1	8302H	No receive resources on the destination station; the receiving
			station cannot process received data quickly enough or has not
			prepared any receive resources.
0	1	8304H	The connection is not established. The send job should only be
			attempted again after waiting for at least 100 ms.
0	1	8311H	The destination station cannot be obtained under the specified
			Ethernet address.
0	1	8312H	Ethernet error on the CP.
0	1	8F22H	Source area invalid, for example:
			Area does not exist in the DB
			LEN parameter < 0
0	1	8F24H	Area error reading a parameter.
0	1	8F28H	Alignment error reading a parameter.
0	1	8F32H	Parameter contains a DB number that is too high.
0	1	8F33H	DB number error.
0	1	8F3AH	Area not loaded (DB).
0	1	8F42H	Timeout reading a parameter from the I/O area.
0	1	8F44H	Address of the parameter to be read is disabled in the access
			track.
0	1	8F7FH	Internal error, e.g. illegal ANY reference.
			e.g. parameter LEN=0
180			SIMATIC NET NCM S7 for Industrial Ethernet
			Release 6/2003

C79000–G8976–C129–07