Siemens SS2524 manual Rear Panel

Introduction

Rear Panel

	Figure 3 Rear Panel
Power port	Connect the supplied power cord here.
Aerial Antenna	Best results are usually obtained with the antenna in a vertical posi-
	tion.
Reset Button	This button has two (2) functions:
	∙ Reboot. When pressed and released, the SpeedStream Powerline
	Wireless Router will reboot (restart).
	∙ Reset to Factory Defaults. This button can also be used to clear
	ALL data and restore ALL settings to the factory default values.
	To Clear All Data and restore the factory default values:
	1. Power Off the router
	2. Hold the Reset Button down while you Power On the router.
	3. Continue holding the Reset Button until the Status (Red) LED
	blinks TWICE.
	4. Release the Reset Button.
	The factory default configuration has now been restored, and the
	Router is ready for use.
WAN port	Connect the DSL or Cable Modem here. If your modem came with a
(10/100BaseT)	cable, use the supplied cable. Otherwise, use a standard CAT5 UTP
	LAN cable.
10/100BaseT	Use standard LAN cables (RJ45 connectors) to connect to your PCs.
LAN connectors	Both 10BaseT and 100BaseT connections can be used simultaneously.
	All 4 LAN ports are capable of being connected to another hub
	with a straight-through cable. Any port will automatically act as
	an “uplink” port when required.

Warning!

The case contains no user-serviceable components. Only qualified service staff should open the case.

5