UM344-2 ON-LINE AND OFF-LINE OPERATION
August 1995
5
-
5
Press ENTER to store the new value in the on-line
alterable memory and return to the Range screen.
Pressing QUIT displays the Range screen without saving
a new value.
NOTE
To conserve battery power, the MXC should not
be left in the Sensor Input mode.
9. At the Range screen, press SEL/CONT to display the
Damping screen and current damping value.
Press EDIT (F1) to enter a new damping value.
Type a new damping value and press either ENTER to save
and exit or QUIT to exit without saving.
10. At the Burnout Direction screen press either LAST OPTN
or NEXT OPTN to choose UPSCALE or DOWNSCALE.
When the desired function is chosen, press SEL/END to
return to the Function Block Menu.
Go to the next section or the next desired function block.
5.1.1.2 Operator Display Block
The Operator Display block has the following parameters:
PROCESS VARIABLE UNITS, RANGE, AUTO RERANGE,
and LOCAL DISPLAY CODE.
1. Press SELECT to edit process variable units.
2. Type the process variable's units. It can be a combination of
up to four alphanumeric characters. To edit, use the < or >
keys to move to the character to be changed.
Press SEL/CONT to continue. Press SEL/END to end
configuration of this block and return to the Function Block
Menu.
3. To set the range in the Operator Display Block, use the "tell"
method described in Section 5.1.1.1 Sensor Input Block. Edit
PV LO and HI in their respective screens by typing the
upper and lower range values desired.
Press SEL/CONT to continue. Pressing SEL/END will end
configuration and return to the Function Block Menu.
DAMPING : 1.0000 SEC
SEL/ SEL/
EDIT END CONT
DAMPING : SEC
ENTER DAMPING VALUE
EN-
< QUIT TER
BURNOUT DIRECTION:
UPSCALE
LAST
OPTN NEXT
OPTN SEL/
END SEL/
CONT
SELECT BLOCK TO EDIT
- OPERATOR DISPLAY -
SEL-
PREV NEXT END ECT
PROCESS VARIABLE
UNITS: EGF
SEL/
END SEL/
CONT< >
RANGE LO: 0.0000
HI: 100.00
EDIT SEL/
END SEL/
CONT