Siemens UM344-2 user manual Method 1 The Tell

ON-LINE AND OFF-LINE OPERATION UM344-2

METHOD 1 - The "Tell"

M V L O : 0 . 0 0 0 0

ENTER MV LO:

		E N -
<	QUIT	TER

Method

M V H I : 1 0 0 . 0 0

ENTER MV HI:

		EN -
<	QUIT	TER

METHOD 2 - The "Show" Method

mV: 79 . 120 deg F - 0 . 0 0 0 0 T O 1 0 0 . 0 0

SET	SET
L O	H I	QUIT	ENTER

8.The Range screen shows the unit of measurement and the lower and upper range values (LRV and URV) currently configured. Set the transmitter's temperature range corresponding to 4 and 20 mA. (See Section 8 for transmitter input ranges.)

These values can be changed using either of two methods: "Tell" or "Show."

Values for URV and LRV entered in the following procedures are stored in the MXC. Complete config- uration and perform the download steps in Section 5.1.2 to send the configuration to a transmitter.

1)Press EDIT (F1) to display the screen for entering the Lower Range Value (LRV).

2)Type the desired value at the blinking cursor.

3)Press either ENTER (F4) to select the value or QUIT (F3) to exit this selection without saving.

4)The next screen displays the transmitter's Upper Range Value (URV) which is set as described above.

In this method, the transmitter is ranged by applying actual URV and LRV sensor inputs.

1)Press SNSR INPT (F2) in the Range screen.

The screen displays the On-Line value for the actual temperature or MV units that the transmitter is reading.

2)Apply the LRV sensor input to the transmitter.

3)Press SET LO (F1) to set the LRV for the transmitter's range.

4)Apply the URV sensor input to the transmitter

5)Press SET HI (F2) to set the URV for the transmitter's range. The screen shows new LRV and URV values.

5-4 September 1995