Sierra SL-800 Operating Instructions, Charging the Cal=Trak Battery, Turning the Cal=Trak On

Variable Area Meter (Rotameter)

Fixed	Adjustable	Sonic	A
Regulator	Regulator	Nozzle

B

Stable Pressure	OR Porous Plug
> 200 kPa

DryCal

Cal=Trak

Figure 13 Setup for Calibrating Rotameters (Variable Area Flow Meters)

8.0Operating Instructions

Charging the Cal=Trak Battery

The Sierra Cal=Trak is powered by an internal lead-acid battery. The battery will power the instrument for 6–8 hours of continuous use and has a typical service life of approximately 2–4 years, depending on use. The Cal=Trak provides a convenient 65-minute automatic shut-off to extend battery life.

Before using your calibrator, be sure that the battery system has been adequately charged to ensure that it will perform to its specifications and maintain operation for the calibration period. If "B" is indicated in the upper right hand corner of the display during operation, recharging is required.

To charge, connect the Sierra supplied charger into a standard wall outlet. Be sure to use only Sierra-approved batteries and AC adapters/chargers for all Cal=Trak flow calibrators. Insert the Cal=Trak charger’s barrel plug end into the charging jack located on the left rear side of the SL-800 base. The green Charge LED will illuminate. Full charge takes 8 –12 hours, and the Cal=Trak can charge while being used. Upon full charge, the charger will taper to a trickle mode automatically. The unit may be charged indefinitely without damage to the battery.

Turning the Cal=Trak On

Press On to start the Cal=Trak. An opening screen will appear indicating the instrument’s software revision level followed by the “Main Menu”.

Turning the Cal=Trak Off

The Cal=Trak has a battery saving automatic shut off system. After 65 minutes of inactivity, the Cal=Trak will shut off. Alternatively, the unit can be shut off manually by pressing the Reset button followed by the number 0 from the “Main Menu”.

LCD Backlight

The Cal=Trak’s LCD display includes a backlight function to illuminate the display. The default setting for the backlight is always on. If you wish to conserve battery power you may wish to turn the backlight off or enable the backlight only when inputting information on the keypad.

To turn the backlight off, from the “Main Menu” press the Light button one time. To enable the backlight only when inputting information on the keypad press the Light button a second time. To return to the default setting of always on, press the Light button a third time.

17