![](/images/new-backgrounds/1110674/110674205x1.webp)
Global Positioning System (GPS)
Sending Reports Automatically
Remote
You can configure the PinPoint X to send reports based on a time interval and on the movement of a vehicle (based on it’s position from one time to the next).
Figure 10-7: AceManager : PinPoint - *PPTIME, *PPDIST, *PPTSV,
*PPMINTIME
•*PPTIME ‐ Location report sent every set time interval (seconds).
•*PPDIST ‐ Location report sent only if the position is more than the set distance (x 100 meters).
•*PPTSV ‐ Location report sent if the vehicle has been in one location (stationary) for more than a set time interval (minutes).
•*PPMINTIME ‐ Location report sent be sent at no less than this time interval (seconds).
Note: If you’re implementing both a time interval and distance interval for reports, the PinPoint X will use the timer which expires first. The reporting interval can impact your data usage. If the interval is set frequently, you may want to have a high usage or unlimited data plan.
Tip: One mile is approximately 1600 meters. 1000 meters is one kilometer.
Local
If you are sending reports on the local serial port, and/or if you want them sent automatically, you will need to set *PPLATS. The time interval, just as for *PPTIME, is in seconds.
Figure 10-8: AceManager : PinPoint - *PPLATS
Report Delay on Power-Up
The PinPoint X can be configured to wait a specific amount of time after initialization before any reports are sent. Configure #IG for the desired wait in seconds.
|
|
|
|
|
|
|
Rev 3.0B Feb.08 |
|
|
|
|
| 90 |
|
|
|