Sierra Wireless 20070914 manual Low Power

Configuration Commands
Rev 3.0B Feb.08 147
•n=minutes
*TPORT=n
SetsorqueriestheportusedfortheATTel net server.If0is
specified,theATTeln etserverwillbedisabled.Thedefault
valueis2332.
•n=0:Disabled.
•n=1‐65535
Tip: Many networks have the ports below 1024 blocked. It is recom-
mended to use a higher numbered port.
*TQUIT
Disconnectsthetelnetsession.NotavailableinAceManager..
Low Power
ThePinPointXwillputitselfintoalowpowerusingmode
whenconfiguredeventsoccur.LowPowermodeisessentially
astandbymodewhichusesminimalpowerwhilebeingready
to“comealive”quickly.
Figure 1-16: AceManager : Low Power
PTMR=n
Numberofminutesafteroneofthepowerdownevents(VTLG
orDTRP)happensuntilthePinPointXentersthelowpower
mode.IfDTRPandVLTGareboth0(zero),thissettingdoes
nothing.
•n=0‐255minutes
Note: There is always a minimum of 1 minute between power down
event and actual shutdown (to give the PinPoint X time to prepare);
entering zero will not power down the modem immediately, but after