Sierra Wireless 20070914 USB, Serial

Configuration Commands
Rev 3.0B Feb.08 126
Caution: STATICIP does not set the IP address of the modem, it
merely tells the modem which IP address to expect. If the expected IP
address is not granted while registering on the cellular network, the
modem will try to register on the network again until it receives that IP
address. If your account is set up for a dynamic IP address and you
set an address for *STATICIP, you may not be able to register on the
network at all since there is no guarantee you will receive the same
dynamic IP address again.
*STATUSCHK=n
ChecksifanSMSmessagehasbeenreceivedbythemodem.
•n=1‐255:Secondsbetweenchecks.
•n=0:Nevercheck.
USB
ThePinPointXisenhancedtowithaUSBportforadditional
connectionoptions.
Figure 1-6: AceManager: USB
*USBDEVICE=n
ThiscommandconfiguresthebehavioroftheUSBport.For
bothmodes,adriversuppliedbyAirLinkwillneedtobe
installedtousetheportaccordingly.
•n=0:Portcanbeusedasavirtualserialport.
•n=1:PortcanbeusedasavirtualEthernetport.
Serial
Thisgroupincludescommandsspecifictogeneraluseofthe
serialport.