Sierra Wireless 20070914 manual String=AT commands, =1‐255 minutes, =1‐255 hours

Configuration Commands

Note: It may take up to 30 seconds for the hardware module to respond after CONNECT is output.

*CSX1=n

PassThru Echo : Echo data to the host.

•n=0 : Data will be passed to the host.

•n=1 : PASSTHRU mode will echo all host received data and will not pass the data to the modem while the modem is not asserting DCD.

Note: If the modem is asserting DCD, data will be passed from the host to the modem as it normally is when *CSX1=0.

*PTINIT=string

Any AT Command string to be passed to the OEM module before entering PASSTHRU mode, e.g. AT&S1V1, etc.

•string=AT command(s)

*PTREFRESH=n

Number of minutes of inactivity in PASSTHRU mode to resend the *PTINIT string to the hardware module.

•n=0 : Disabled

•n=1‐255 minutes

*RESETPERIOD=n

In PASSTHRU mode, modem will be reset after this period if no data has been sent or received. Value is in hours.

•n=0 : Disabled

•n=1‐255 hours

SMTP

SMTP (Simple Mail Transfer Protocol) is the de facto standard for email transmission across the Internet. The PinPoint X can send messages using SMTP if it has been configured to use a mail server.

Note: You cannot send an Email with your PinPoint X unless the Email server you have configured allows your PinPoint X as a relay host. Talk to your network administrator to ensure you can send email through the email server using your PinPoint X.

Rev 3.0B Feb.08 141