Global Positioning System (GPS)
Support for a COM1000 is enable with the command *PPCOM1000=1 or *PPREPORTINPUTS=1. Once enabled, ALEOS will receive the reports from a properly configured COM1000 and add the state of the extra inputs to RAP packets sent to the RAP Host.
Figure 10-22: AceManager : *PPCOM1000, *PPREPORTINPUTS
If you are replacing an existing Pinpoint or PinPoint‐E in a vehicle with a COM1000, simply replace earlier modem with the with the PinPoint. Turn on COM1000 reporting with the command *PPCOM1000=1 to allow a seamless transition with no need to change any commands to support the COM1000 in the same operation as the previous installation.
If you have a new vehicle installations for the PinPoint and have previously installed Pinpoints or PinPoint‐E modems plus COMM1000 in other vehicles, connect the inputs directly to the PinPoint and turn on input reporting with the command *PPREPORTINPUTS=1. Since the PinPoint inputs report using the exact same bit fields as the COM1000, no changes to your software should be required.
Caution: If both *PPCOM1000 and *PPREPORTINPUTS are enabled, the PinPoint X digital inputs will be reported and the COM1000 inputs will be ignored.
The report type will indicate the state of change in the inputs. The contents of the report will be the same as Report Type 0x12 (GPS data with date) or 0x13 (GPS data with date and RF data) with the addition of the event report.
Flush on Event
If you have Store and Forward configured and enabled, to receive event reports immediately when they occur, you will want to enable *PPFLUSHONEVT. This will cause all pending reports, including the triggering event, to be sent immediately to the Host.
Figure 10-23: AceManager : *PPFLUSHONEVT
|
|
|
|
|
|
|
Rev 3.0B Feb.08 |
|
|
|
|
| 97 |
|
|
|
