Face plate
Putting the face plate on
•Place the face plate with the left side in the frame first. Then firmly press the right side until it locks into place.
•Check to make sure that the face plate is firmly and correctely installed in the frame. If the face plate is incorrectely installed it can result in mal- functions when operating the car radio.
Removing the face plate
•Press the button to unlock the face plate.
•To remove the face plate first tip it slightly forward and pull the right side away first and then the left side.
Note
When the face plate is not inserted into the frame the theft protection LED on the device blinks.
To safeguard the face plate always keep it stored in its case.
Remote control
Inserting the battery
Remove the supplied battery from the packing. To insert the battery and/or change the battery proceed as follows:
•Pull the battery compartment out of the remote control by first pressing the lateral locking device and then pulling the battery compartment out.
•Remove the depleted battery and insert a new battery of the type CR2025 (Button cell) into the battery compartment. Make sure that the battery is inserted in accordance with its correct polarity.
•Slide the battery compartment back into the re- mote control.
Using the remote control
•Point the remote control to the Infrared sensor on the front panel of the device.
•You can use the remote control for distances of up to approx. 8 m from the device.
- 57 -
