5 SWITCHING ON AND OFF
The HT300 LINK system consists of the Projector and the DigiOptic™ Image Processor (which is also the system control centre). The DigiOptic™ Image Processor sends commands to the Projector and receives operating status information from the Projector and function commands from the user. The system can be controlled from either the remote control (via the infrared sensors on the DigiOptic™ Image Processor and on the Projector) or the keypad located on the rear of the Projector.
The two units have separate power supplies however: after connecting the unit to the electrical mains supply:
1)Set the two power switches to “I”; the DigiOptic™ Image Processor power switch is located on the external power supply unit (Fig. 13c), while the Projector switch is on the rear panel (Fig. 13a).
2)Turn on the DigiOptic™ Image Processor by pressing the button on the front panel (Fig. 13b).
Fig.13a
Fig.13a
I |
|
|
|
|
|
O |
|
|
|
|
|
| I |
|
|
|
|
| O |
|
|
|
|
|
| D |
|
|
|
|
| IGIOPTI |
|
|
|
|
| C ™ | IMAGE |
|
|
|
|
| PRO |
| |
Fig.13c |
|
|
| CESSOR | |
|
|
|
| ||
|
|
|
| ON | |
Fig.13c |
|
|
|
| OFF |
|
|
|
|
| |
| IMA |
|
|
|
|
| GE | PROCE |
|
|
|
|
|
|
|
| |
|
| SS |
|
|
|
|
| OR |
|
|
|
|
| ON |
|
|
|
|
| O |
|
|
|
|
| FF |
|
|
|
Fig.13b
Fig.13b
After a few seconds (system initialisation interval), the DigiOptic™ Image Processor and the Projector assume stand- by mode.
System status information is provided by two LEDs (green and blue) on the front panel of the DigiOptic™ Image Processor, a blue and green LEDS on the rear of the Projector.
Significant status signals are given in Table 3.
Table | 3 |
| |
| DigiOptic Image | Projector | |
Status | Processor | ||
| |||
| Green LED Blue LED Green LED Blue LED | ||
Off |
|
|
Initialisation
On
Cooling
Optical link not active
Caution |
|
| - | - |
Error |
|
| - | - |
: Off | : On | : Flashing |
If the “No optical link” or “Error” signals are active the system cannot be operated; if the “Warning” signal is active the system will operate but it may be unable to read certain input signals correctly.
SWITCHING ON FROM STAND-BY
Switching on the system (Fig.14):
•from the remote control (keys
•from the Projector keypad (keys and ).
0
LIG | RC | I |
| HT | 2005 |
Fig.14
13