Sim2 Multimedia HT300 Link installation manual Memories, Image Picture

MEMORIES

The main parameters of the image may be saved in distinct groups of values (known as ‘Memories’); these parameters can subsequently be applied all together by way of a single com- mand.

There are 3 distinct Memories (Memory 1, Memory 2, Memory

3) for each of the 25 signal types managed:

1	VIDEO
2	VIDEO
3	S-VIDEO
4	S-VIDEO

5	COMP/RGB(YCrCb 15KHz)	5	COMP/RGB(RGB 15KHz)
5	COMP/RGB(YCrCb 32KHz)	5	COMP/RGB(RGB 32KHz)
6	COMP/RGB(YCrCb 15KHz)	6	COMP/RGB(RGB 15KHz)
6	COMP/RGB(YCrCb)	6	COMP/RGB(RGB)
7	COMP/RGB(YCrCb 15KHz)	7	COMP/RGB(RGB 15KHz)
7	COMP/RGB(YCrCb)	7	COMP/RGB(RGB)
8	COMP/RGB(YCrCb 15KHz)	8	COMP/RGB(RGB 15KHz)
8	COMP/RGB(YCrCb)	8 COMP/RGB(RGB)

9 GRAPHICS RGB

10	GRAPHICS RGB
11	DVI-D (RGB)
11	DVI-D (YCrCb)
12	HDMI

making a total of 75 different available Memories.

The image parameters that can be saved/recalled by the Memo- ries management system are the following:

Image	Picture
BRIGHTNESS	ASPECT
CONTRAST	COLOR TEMP. GAIN (R/G/B)
COLOR	COLOR TEMP. GAIN OFFSET (R/G/B)
TINT	COLOR TEMP.
SHARPNESS	OVERSCAN
FILTER	GAMMA
SHARPNESS MODE
VIDEO TYPE
NOISE REDUCTION

Some of these parameters may not be available for certain in- puts or certain input signals, as indicated in Tables 4 and 5. The menu page for the Memories management functions is

activated by pressing the key on the remote control or the

￿key on the keypad (Fig.28).

2005

ZOOM

F1

Fig.28 The operations that can be performed on each memory se- lected are described here below.

SAVE A MEMORY

To save the current values of the image parameters in Memory 1, use the ￿ and ￿ keys to move to line ‘1’ and then open the pull-down menu by pressing the ￿ key (Fig.29). Then select the option ‘Save current settings’. To confirm that the operation has been completed successfully, the message ‘Current set- tings saved in Memory 1’ is displayed at the bottom of the screen and the letter ‘S’ appears to the left of the memory name. The same procedure is used to save parameters in Memories 2 and 3.

Memories
0	Auto
1	S	Save current settings
2	I	Save initial settings
3	S	MEMORIARename 1

Fig.29

RECALL A MEMORY

To recall a Memory, select the desired line and press ￿. The parameters saved in the selected Memory will be applied to the image displayed and a message will appear to confirm the operation ‘Memory 1 recalled’. The Memory recalled will be associated with the source and signal type, and will be auto- matically recalled every time that particular source and signal type combination is selected.

24