Sim2 Multimedia HT300 Link installation manual Read this manual carefully and keep it in a safe

• Read this manual carefully and keep it in a safe

place for future consultation.

This manual contains important information on how to install

and use this equipment correctly. Before using the

equipment, read the safety prescriptions and instructions

carefully. Keep the manual for future consultation.

• Do not touch internal parts of the units.

The units contain electrical parts carrying high voltages and

operating at high temperatures. Do not remove the cover

from the units, refer to qualified service personnel for all repair

and maintenance requirements.

The warranty will be automatically invalidated if the cover is

removed from the units.

• Power supply disconnect device.

The device for disconnecting the units from the mains power

supply is constituted by the power cable plug. Ensure that

the power cable plugs and the electrical mains socket outlets

are easily accessible during installation operations. To

disconnect the units from the electric power supply, pull the

plug to remove it from the socket outlet. Do not pull the power

cable.

• Use only the specified type of mains power

supply.

Connect the units to a mains electrical supply with rated

voltage of between 120-240 VAC, 50/60 Hz and equipped

with a protective earth connection. If you are unsure of the

Fig.2

• Replace the safety fuse

4

250 V

T 3.15A H

2

type of mains power supply in your home, consult a qualified

electrician.

Ensure that the power draw of the units is commensurate

with the rating of the electrical socket outlets and any

extension cables that are used.

1

3

Fig.3

For the DigiOptic™ Image Processor use exclusively the

power supply unit provided or an alternative power supply

unit expressly approved by SIM2.

Fig.1

•Beware of power supply cables.

Position the power supply cables so that they do not constitute an obstruction.

Position the power supply cables where they cannot be reached by children.

Install the units as close as possible to the wall electrical socket outlet. Do not tread on the power cables, make sure that they are not tangled or pulled; do not expose the power cables to heat sources; make sure that the power cables do not become knotted or kinked. If the power cables become damaged, stop using the system and request the assistance of an authorised technician.

5